恶臭假单胞菌Pseudomonas putida 5-x细胞壁膜系统的Cu2+吸附性能

对1株从电镀废水中分离出的革兰氏阴性菌恶臭假单胞菌P.putida 5-x的细胞表面组分对Cu²⁺的吸附性能进行了分析研究.结果表明,分离的P.putida 5-x细胞壁膜的Cu²⁺吸附容量是完整细胞的5倍之多.细胞表面组分如肽聚糖层、细胞外膜和细胞内膜在P.putida 5-x细胞壁膜的Cu²⁺吸附过程中都发挥了作用.肽聚糖层、细胞外膜和内膜在P.putida 5-x细胞壁膜中的含量依次为细胞内膜>外膜>肽聚糖层,而它们的Cu²⁺吸附容量的大小依次为肽聚糖层>外膜>内膜.在P.putida 5-x细胞壁膜对Cu²⁺的吸附过程中,肽聚糖层贡献了不到15%的吸附容量,而细胞外膜和内膜分别贡献了30%～35%和25%～30%.P.putida 5-x细胞外膜中的磷脂含量明显比其它报道的革兰氏阴性细菌的细胞外膜高,这可能是P.putida 5-x细胞外膜具有较高Cu²⁺吸附容量的主要原因,并由此导致P.putida 5-x细胞壁膜的高Cu2+吸附容量.     

新型单室无质子膜微生物燃料电池性能研究

采用不锈钢金属丝阳极构建了管状单室无质子交换膜空气阴极微生物燃料电池(MFC),并以葡萄糖为唯一电子供体,研究MFC的性能.在室温下,初始ρ(CODCr)为496 mg/L,外接电阻为1 000 Ω时,该MFC可以连续产电,最高电压达235.11 mV,开路电压为461.00 mV,内电阻约2 820 Ω.实验条件下测得该MFC的最大功率密度为137.1 mW/m2,库仑效率为32.4%.采用该MFC进行了啤酒酿造废水处理对比实验,在进水ρ(CODCr)为15 900 mg/L,停留时间为96 h下,MFC对废水CODCr的去除率达40%～55%,比厌氧生物处理效率高5%～10%.表明MFC技术可以在获得电能的同时,强化有机废水的生物处理过程.     

不同酶强化污泥为燃料微生物燃料电池特性对比分析

采用单室无膜悬浮阴极微生物燃料电池(MFC),对比分析了蛋白酶和淀粉酶强化剩余污泥为燃料的MFC(ESMFC)产电特性、酶特性和污泥减量化效果。研究表明,投加蛋白酶的ESMFC最大功率密度比对照组增加106.2%,投加淀粉酶时ESMFC最大功率密度比对照组增加48%。蛋白酶作用主要体现在投加后的前12小时,而淀粉酶作用时间则较长,为投加后的前144小时,但在运行前期,由于高温作用,导致系统内的酶活性较强,投加的淀粉酶作用则不明显。投加蛋白酶的系统内TCOD、TSS和VSS去除率分别为82%、65%和85%,而投加淀粉酶的系统内TCOD、TSS和VSS去除率分别达到86%、67%和88%。此研究对于ESMFC中外加酶的选择具有一定意义。     

Improving photostability and efficiency of polymeric luminescent solar concentrators by PMMA/MgO nanohybrid coatings

MgO nanocrystals were synthesized and doped with different concentrations in poly(methylmethacrylate) (PMMA) to prepare hybrid organic-inorganic coatings based on polymer nanohybrid thin films. The nanoparticles were found to be spherical with 62 nm diameter as determined by X-ray diffraction (XRD) and atomic force microscope (AFM). The coatings were characterized by spectroscopic tools such as optical absorption, transmission and fluorescence spectroscopy. The prepared nanohybrid films were spin-coated on cost-effective luminescent PMMA substrates doped with highly efficient luminescent dyes luminescent solar concentrators (LSCs). The outdoor photostability tests demonstrated enhanced protection against UVA radiation for coated LSCs compared to bare LSC substrates. The current–voltage characteristics of commercially produced LSC prototypes showed that the poor UV response of monocrystalline silicon solar cell can be improved by for LSCs coated by PMMA/MgO nanohybrid films which act as luminescent down shifting layer (LDSL).     

新型硅镁胶(MgO·2SiO_2)对模拟放射性废水中Co~(2+)的吸附性能

以泡花碱和氯化镁为原料合成出了一种新型硅镁胶(MgO·2SiO2)吸附材料,用傅里叶红外光谱仪对其进行了表征,并对模拟放射性废水中的Co2+进行吸附实验。结果表明,控制合成pH在10.50~11.00,可以得到目标硅镁胶(MgO·2SiO2),在460 cm-1处出现了较强的吸收峰,这是由Mg—O伸缩振动和Si—Mg—O弯曲振动引起。在500℃焙烧4h后,可以得到吸附性能良好的硅镁胶,随着溶液pH的升高,去除率增大,在pH为4~8时达到最大。25℃时,最大吸附量可达135.5 mg/g,吸附过程符合Langmuir等温吸附方程和准二级动力学方程。重复使用4次,对Co2+的吸附量仍然达到130 mg/g,说明硅镁胶是一种可重复利用的吸附剂。     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。     

Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.     

The impact of pesticides on oxidative stress level in human organism and their activity as an endocrine disruptor

Pesticides cause serious environmental and health problems both to humans and animals. The aim of this review is to discuss selected herbicides and fungicides regarding their mode of action and their influence on basic oxidative stress parameters and endocrine disruption properties tested in selected cell cultures in vitro. Because of numerous difficulties which animal studies are subject to, cell cultures are an excellent experimental model reflecting human exposure to different pesticides through all relevant routes. This experimental model can be used to monitor aggregate and cumulative pesticide exposures.     

Development of a fuel cell propulsion system for the existing Mercedes B-Class 160 of petrol driven car

This paper presents a theoretical comparison between fuel cell (FC) power train and conventional petrol driven propulsion system. FC has potential to reduce the CO₂-emissions from road. However, FC power trains require energy storing device, to meet the peak power during extreme drive situations and also able to recover the kinetic energy of the vehicle during break operation. The proposed system includes a polymer electrolyte membrane fuel cell (PEMFC) based drive train and a super capacitor connected in parallel. The system is designed and dimensioned for a conventional petrol driven propulsion system of the Mercedes B-Class160. The feasibility study also includes comparison between the existing conventional systems. It is shown that although FC power train is heavier compared to existing system, urban performance is better and produces no CO₂ and other harmful emissions.     

β-环糊精接枝羧甲基壳聚糖吸附剂的制备及其性能

采用γ-氨丙基三乙氧基硅烷化学修饰活化后的硅胶,以戊二醛为交联剂,接上羧甲基壳聚糖,继而接枝上β-环糊精作为功能单体,制备了一种用于分离富集水样中Cu(Ⅱ)的固相萃取新材料。利用红外光谱(FT-IR)、比表面分析(BET)、X射线衍射光谱(XRD)以及热重分析(TG)等方法对吸附剂进行结构表征。采用火焰原子吸收(FAAS)作为检测手段,考察了溶液p H、振荡时间、吸附剂用量、样品流速、洗脱液浓度和体积等对吸附剂吸附Cu(Ⅱ)的影响。吸附剂饱和吸附容量为9.37 mg/g,最大富集倍数高达350。吸附过程能用准二级动力学模型和Langmuir等温吸附方程进行很好的拟合。应用于环境水样中Cu(Ⅱ)的分离富集与测定,回收率在96.8%~105.2%之间,效果较好。